FAAC supplier, installation & repair in Ajman

QNAD supplies sliding, swing, underground and ram gate motors and fits them in Ajman, Sharjah and Dubai. We choose the motor from the gate type, leaf weight and length, how often the gate is used and the power available, then quote it in writing after a free site visit.

We also replace failed motors, control boards and receivers on gates that are already installed. Motors from Beninca, BFT, CAME, FAAC, Nice, Roger Technology, VDS and Somfy can be fitted. See gate motor supply.

A small seep at a fitting or seal can often be repaired by replacing the seal or tightening the connection and topping up the oil. A heavy leak with a leaf that no longer holds position suggests worn internal parts. We clean the unit, find the leak source, check the oil level and test how well the leaf holds against pushing.

Whether replacement parts can be obtained depends on the model, so we confirm that on site before suggesting repair.

This is nearly always the safety circuit. A photocell with a dirty or misaligned lens, a damaged cable, or a safety edge that has been pressed will tell the board to refuse closing. Some boards also have a setting that stops auto-close after an obstruction was sensed.

You can wipe the photocell lenses and check that nothing blocks the beam. If the gate still will not close, a technician will test each safety input on the board to find which one is open.

A barrier arm that bounces on lifting or sags afterwards usually has a balancing issue. The spring may have weakened, the arm may have been replaced with a different length or weight, or an accessory such as a skirt or lights has changed the load. A worn drive part can also let the arm fall.

We check the spring tension, arm weight, drive and mounting, and rebalance it so the arm holds at any point of travel.

That depends on how many cycles the gate performs. A busy compound entrance with hundreds of passages a day wears faster than a private villa gate. As a guide, busy sites benefit from regular scheduled visits, and villas from a yearly check before the hot season.

A visit covers lubrication, hinges or wheels, hydraulic or gearbox condition, limit settings, safety devices and the release. We will suggest a visit interval after seeing your gate.

Tell us the gate type (sliding, swing or barrier), roughly how old it is and what the fault looks like. If you can, send a photo of the operator and its label. Note any recent events such as a power cut, a vehicle hit or building work near the gate.

Keep the area around the gate clear and have the remotes and any keypad ready, so we can test every way of operating it.

Yes, we install and service automatic doors and gates across Ajman, from Al Nuaimiya, Al Rashidiya and Al Rawda to Al Jurf Industrial Area, Emirates City and Ajman Free Zone. Our head office is in Al Aalia.

Villas, apartment buildings, workshops and warehouses all fall within our coverage, including Al Hamidiya, Al Mowaihat, Al Zahra, Al Bustan, Al Rumaila, Ajman Corniche and Masfout. Call us with your location. See our sliding gates and garage doors.

A sliding entrance door moves sideways into a pocket or along the wall, so it needs no clearance in front of or behind the opening, which makes it the default choice for narrow shopfronts and mall entrances with heavy foot traffic. A swing door pushes open into the room or the street and needs clear space on the swing side.

Sliding doors generally handle higher footfall better and are easier to fit with an air curtain to keep air conditioning in. Swing doors can look more premium on boutique entrances and cost less to install. We fit both, and for most retail units in Ajman and Sharjah we recommend automatic sliding glass doors.