The board is sensing an obstruction or a safety trigger at the end of the close cycle. A photocell that is knocked out of line, dirty or wired loosely is the first suspect. A force setting that is too low, or a gate that binds slightly at the end of travel, can also cause it.
We check the sensors, wiring and force setting, then move the gate by hand to feel for stiffness. Fixing the cause is better than turning the sensitivity down.
Who this applies to
This answer is for owners, tenants and facility managers in Ajman who want a clear answer. It describes general practice. The right solution for your gate, door or shutter depends on the equipment, the site and how often it is used, which is why we look at it on site before we quote.
What to do next
- Describe your situation and the equipment involved, with the brand if you know it.
- Add photos of the opening or the unit through the quote form.
- We call you to arrange a free site visit.
- After the visit you receive a written quote.
Where we help with this in Ajman
We attend sites across Ajman. These locality pages list the services, nearby areas and questions for each place.
Automatic gates and barriers
Send a photo or the rough size and we call you to book a free site visit, then give you a written quote.